Testing tool

Non-destructive identification of elastomers material (only for material, not for the hardness)

Identification of following material:
E = Ethylen-propylene-diene rubber (EPDM)
P = Acrylonitrile-butadiene rubber (NBR)
V = Fluorocarbon Rubber (FKM, FPM, VITON®)

Method of measurement:
- Lay down the sample on a hard support and place the tester upright on the sample. Take the
  reflection solid (stud in the tube) on the pin to the upper limit.

- Release the pin. Observe and notice the height of the spring back (V, P or E). The heights can
  slightly vary by diffrent manufacturers, lots and compounds.

Adventage:
Avoidance of consequential damage
Identification of required material before use